Categories
Máy tính công nghiệp ADLINK
PLASTIM
KAI SUH SUH
- RJ45 Modular Plug And Plug Cover
- Bushings
- Cable Clamps
- Cable Marker
- Cable Tie
- Fasteners
- Terminal
- Cord End Terminal
- Cord End Terminal (double)
- Male Lug
- Non Insulated Cord End
- Blade Terminal
- Flanged Spade Terminal
- Fully Receptacle
- Hook Terminal
- Insulated Bullet
- Insulated Ring Terminal
- Insulated Ring Terminal Easy Entry
- Insulated Y Terminal
- Insulated Y Terminal Easy Entry
- Pin Terminals
- Ring Terminal
- Y Terminal
- Tubes
- Wire Connectors
- Wrapping Bands
PHOENIX CONTACT
- SCHNEIDER
Phoenix Contact
Thiết bị chống sét lan truyền đường nguồn 1P 40kA – Type 2 surge arrester – VAL-MS 230/1+1 – 2804429
Your advantages
- With or without floating remote indication contact
- Multi-channel type 2 arresters
- Optical, mechanical status indication for the individual arresters
- Disconnect device on each individual plug
- Mechanical coding of all slots
- Type 2 consistent plug-in surge arresters


Bộ chống sét/chống quá áp cấp 2 dùng cho nguồn 1 pha, 2 dây ( L1, N, PE ) dùng trong các tủ phân phối điện trong từng phân xưởng, từng tầng nhà. Imax: 40KA, Uc: 275KVA, Up: 1.5KV; gắn trên thanh DIN rail NS 35.
Sơ đồ:
Dimensions
Height | 89.8 mm |
---|---|
Width | 35.6 mm |
Depth | 65.7 mm (incl. DIN rail 7.5 mm) |
Horizontal pitch | 2 Div. |
Ambient conditions
Degree of protection | IP20 (only when all terminal points are used) |
---|---|
Ambient temperature (operation) | -40 °C … 80 °C |
Ambient temperature (storage/transport) | -40 °C … 80 °C |
Altitude | ≤ 2000 m (amsl (above mean sea level)) |
Permissible humidity (operation) | 5 % … 95 % |
Shock (operation) | 25g (Half-sine / 11 ms / 3x ±X, ±Y, ±Z) |
Vibration (operation) | 5g (10 … 500 Hz / 2.5 h / X, Y, Z) |
General
IEC test classification | II |
---|---|
T2 | |
EN type | T2 |
IEC power supply system | TN-S |
TT | |
Mode of protection | L-N |
L-PE | |
N-PE | |
Mounting type | DIN rail: 35 mm |
Color | jet black RAL 9005 |
Housing material | PA 6.6 |
PBT | |
Degree of pollution | 2 |
Flammability rating according to UL 94 | V-0 |
Type | DIN rail module, two-section, divisible |
Number of positions | 2 |
Surge protection fault message | optical |
Protective circuit
Nominal voltage UN | 240/415 V AC (TN-S) |
---|---|
240/415 V AC (TT) | |
Nominal frequency fN | 50 Hz (60 Hz) |
Maximum continuous operating voltage UC (L-N) | 275 V AC |
Maximum continuous operating voltage UC (L-PE) | 275 V AC |
Maximum continuous voltage UC (N-PE) | 260 V AC |
Rated load current IL | 80 A |
Residual current IPE | ≤ 5 µA |
Standby power consumption PC | ≤ 120 mVA |
Nominal discharge current In (8/20) µs | 20 kA |
Maximum discharge current Imax (8/20) µs | 40 kA |
Follow current interrupt rating Ifi (N-PE) | 100 A |
Short-circuit current rating ISCCR | 25 kA |
Voltage protection level Up (L-N) | ≤ 1.35 kV |
Voltage protection level Up (L-PE) | ≤ 1.6 kV |
Voltage protection level Up (N-PE) | ≤ 1.5 kV |
Residual voltage Ures (L-N) | ≤ 1.35 kV (at In) |
≤ 1.1 kV (at 10 kA) | |
≤ 1 kV (at 5 kA) | |
≤ 0.9 kV (at 3 kA) | |
Residual voltage Ures (L-PE) | ≤ 1.6 kV (at In) |
≤ 1.2 kV (at 10 kA) | |
≤ 1 kV (at 5 kA) | |
≤ 0.9 kV (at 3 kA) | |
Residual voltage Ures (N-PE) | ≤ 0.4 kV (at In) |
≤ 0.25 kV (at 10 kA) | |
≤ 0.15 kV (at 5 kA) | |
≤ 0.1 kV (at 3 kA) | |
TOV behavior at UT (L-N) | 335 V AC (5 s / withstand mode) |
440 V AC (120 min / safe failure mode) | |
TOV behavior at UT (N-PE) | 1200 V AC (200 ms / withstand mode) |
Response time tA (L-N) | ≤ 25 ns |
Response time tA (L-PE) | ≤ 100 ns |
Response time tA (N-PE) | ≤ 100 ns |
Max. backup fuse with V-type through wiring | 80 A (gG) |
Max. backup fuse with branch wiring | 125 A (gG) |
Connection data
Connection method | Screw connection |
---|---|
Screw thread | M5 |
Tightening torque | 3 Nm (1.5 mm² … 16 mm²) |
4.5 Nm (25 mm² … 35 mm²) | |
Stripping length | 16 mm |
Conductor cross section flexible | 1.5 mm² … 25 mm² |
Conductor cross section solid | 1.5 mm² … 35 mm² |
Conductor cross section AWG | 15 … 2 |
Connection method | Fork-type cable lug |
Conductor cross section flexible | 1.5 mm² … 16 mm² |
UL specifications
SPD Type | 4CA |
---|---|
Maximum continuous operating voltage MCOV (L-N) | 275 V AC |
Maximum continuous operating voltage MCOV (L-G) | 275 V AC |
Maximum continuous operating voltage MCOV (N-G) | 260 V AC |
Nom. voltage | 230 V AC |
Mode of protection | L-N |
L-G | |
N-G | |
Power distribution system | Single phase |
Nominal frequency | 50/60 Hz |
Measured limiting voltage MLV (L-N) | 1910 V |
Measured limiting voltage MLV (L-G) | 2630 V |
Measured limiting voltage MLV (N-G) | 1370 V |
Nominal discharge current In (L-N) | 20 kA |
Nominal discharge current In (L-G) | 20 kA |
Nominal discharge current In (N-G) | 20 kA |
UL connection data
Conductor cross section AWG | 10 … 2 |
---|---|
Tightening torque | 30 lbf-in. |
Standards and Regulations
Standards/regulations | IEC 61643-11 2011 |
---|---|
EN 61643-11 2012 |
Environmental Product Compliance
China RoHS | Environmentally Friendly Use Period = 50 years |
---|---|
For details about hazardous substances go to tab “Downloads”, Category “Manufacturer’s declaration” |
Classifications
eCl@ss
eCl@ss 4.0 | 27130800 |
---|---|
eCl@ss 4.1 | 27130800 |
eCl@ss 5.0 | 27130800 |
eCl@ss 5.1 | 27130800 |
eCl@ss 6.0 | 27130800 |
eCl@ss 7.0 | 27130805 |
eCl@ss 8.0 | 27130805 |
eCl@ss 9.0 | 27130805 |
ETIM
ETIM 2.0 | EC000941 |
---|---|
ETIM 3.0 | EC000941 |
ETIM 4.0 | EC000941 |
ETIM 5.0 | EC000941 |
ETIM 6.0 | EC000941 |
ETIM 7.0 | EC000941 |
UNSPSC
UNSPSC 6.01 | 30212010 |
---|---|
UNSPSC 7.0901 | 39121610 |
UNSPSC 11 | 39121610 |
UNSPSC 12.01 | 39121610 |
UNSPSC 13.2 | 39121620 |
UNSPSC 18.0 | 39121620 |
UNSPSC 19.0 | 39121620 |
UNSPSC 20.0 | 39121620 |
UNSPSC 21.0 | 39121620 |
Sản phẩm tương tự
-
PHOENIX CONTACT
Plug-in bridge – FBS 10-6 – 3030271
₫2.28Mua hàng*Description: Plug-in bridge, pitch: 6.2 mm, width: 60.3 mm, number of positions: 10, color: red
*Country of origin: DE (Germany)
Your advantages
-The 2- to 50-pos. jumpers can bridge up to 50 terminal blocks in the two bridge shafts of the CLIPLINE complete system in one step
-
PHOENIX CONTACT
End clamp – E/UK – 1201442
₫0.80Mua hàng*Description: End clamp, width: 9.5 mm, height: 35.3 mm, material: PA, length: 50.5 mm, Mounting on a DIN rail NS 32 or NS 35, color: gray
*Country of origin: IN (India)
Your advantages
-With universal foot for NS 35 and NS 32 DIN rails
-Tall and low-profile designs
-Large-surface labeling

Giỏ hàng
Liên hệ:
Phoenix Contact
ADLINK – Máy tính Công nghiệp
KSS (đầu Cos, phụ kiện KSS)
Đánh giá
Chưa có đánh giá nào.